logo
   |First page|Romana  |
OVER   90  YEARS OF EXPERIENCE IN THE DRILLING DOMAIN
image
image image image image image
| ABOUT  US  |  DRILLING ACTIVITY |  ENDOWMENT  | AUXILIARY ACTIVITIES |  CONTACT  |
AUXILIARY ACTIVITIES  

SWACO 518 Centrifuge

Removes light fluids from the drill-hole after the primary clean; For easy fluids drilling, the solids removal ratio can be increased through the RPM change, obtaining other centrifugal forces, managing a particle separation down to 2 microns in this way : for 1900 RPM with 250 GPM we obtain 6-9 microns particles and at 3250 RPM 2-3 microns particles.
The wheel assembly is composed of an cylindrical section with a 353 mm diameter and 900 mm long of steel and a conical secition with 190 mm small diameter and 353 mm big diameter, 8.5 degrees conicity and a 560 mm lenght of steel.

SWACO 414 Centrifuge

It is usually used as a barium recoverer, the quantity beeing reintroduced in the active sistem of the fluid circulation; it can be efficiently used for low-density liquid (removing 5-7 microns particles) as well as for high density particles (6-10 microns)
The rotating assembly has almost the same dimensions as the SWACO 518 centrifuge, the difference beeing the lenght of the cylindrical section which is 300 mm (where the liquids are separated from the solids) . The rotor generates forces from 500 G's up to 3176 G's at speedes of 1600 RPM respectively 400 RPM at a long operating time. The robustness of the security sistems that restrain vibrations and torsions (the same as SWACO 518), minimising the upkeep and maximising the operating time.












| ABOUT US  | DRILLING ACTIVITY  | ENDOWMENT |  AUXILIARY ACTIVITIES  | CONTACT |
2008 © TMDRILL